for Long
Radius Bending of High-Purity Electropolish Tubing
Bend stainless steel,
steel, brass, aluminum, soft and some hard copper, and other tubing materials.
Each tool bends one size tubing up to
180 degrees. The open side slips over the tube at any point. You get smooth,
long radius bends with no marking, scraping, or flattening. No need to figure
spring-back -- it has been done for you.
In stock and ready to ship
world-wide.
Wire transfer only for international
orders, please.
CALL JOHN SPRAY AT PRO-BEND INDUSTRIES at 408-499-4891
Each fixed-hook tubing bender
is available for 1/4", 3/8" and 1/2" O.D. Different radiuses
are available in all three sizes of benders.
All benders have easy 90 degree
start.
KBS Tubing Benders have roller
bearing glide for ease of bending. The calibration marks and roller
bearing make accurate bends with less effort. The wide fixed hook simplifies
operation and holds the tubing securely. Extra long handles and large
grips give the tool a good feel. Also available are vice or bench bolt
down mounts to allow the jobs to run smoothly.
Internal cracking of the electro-polished
surface is greatly reduced, thereby minimizing particle generation during
installation.
System consists of 10X the tubing
diameter, which equals 2 1/2" radius on 1/4" benders. With
the matching 2 1/2" radius in 3/8" and 1/2" tubing benders,
your orbital welding labor will be cut by a minimum of 70%.
You save material costs by not
buying those long radius 90 degree bends.
Expensive pre-fabricated fittings
are eliminated, for a savings of 10% over a welded system on an average
high-purity installation.
This system has been approved
and used in major micro-electronic facilities and by contractors throughout
the United States. Some satisfied
customers include; Semi Gas, IBM, Intel, Hewlett Packard, AT&T,
Kinetic Systems, Helwig Plumbing and ICOM Mechanical.